Garelick Transom Platform with Telescoping Ladder

● Mount hand rails to platform by inserting 4 bolts through holes in platform. Secure with 4 locknuts.
● Mount SS strut 22" by inserting bolt through hole and secure with locknut.
● Mount SS strut 11" by inserting two bolts thorugh holes and secure with 1 locknut.
● Choose most suitable side of transom for mounting platform. Turn motor unit as far as possible to that side. Make a line on the transom indicating motor unit's full extension to that side.
● Position platform away from drawn line at desired mounting location, parallel to the water line and mark 4 mounting holes through flattened ends of rails and/or struts onto the transom.
● Drill four marked holes with a bit compatible with selected fasteners (fasteners not provided). Hold drill perpendicular to transom when drilling.
● If transom is less than 2" tkick, it's recommended that a backing plate be mounted on the inside of transom.

● NOTE.: The backing plate should be made of either aluminum, marine plywood or sorne other suitable non-compressive material.

● Coat the mounting surfaces of the rails and/or struts with a marine grade adhesive/caulking compound; Squeeze a small amount into mounting holes in transom. Insert selected bolts through holes and secure in positiion with suitable fasteners.

● Periodically check mounting hardware and re-tighten (due to normal boat operation)
● Regular fresh water rinsing and periodic cleaning with a mild abrasive cleaner will help retain luster and help prevent corrosion.