By creating an account at francobordo.com you can make your purchases quickly in our virtual store, check the status of your orders and check your previous operations.
Ahead! We were waiting for you.
Mercury Air Filter L-6 Verado
● Compatible with Verado L-6 outboards.
Mercury Remote Control in Panel-Gen II - Locking Bar
● The mounting panel control has a chromed handle and carries a 4 ft (1.22 m) compensation wiring harness with the 3-pin Molex connector.
● All installations require an ignition / choke assembly and independent acceleration / change cables to complete the installation.
● The neutral safety switch wires measure 6.5 ft (1.98 m) and have a bullet-type connector at the ends.
● Man-to-water switch c...
336,30€
on request: Mercury Remote Control in Panel-Gen II - Locking Bar
It can be more than 30 daysTAX incl.
Mercury Water Pump Repair Kit 8M0100526
Mercury 47-8M0100526 Water Impeller Repair Kit. Fits ● 40/45/50/60 FourStroke Bigfoot● 60 (3 cyl.) BigFoot● 75.125 (all 3 & 4 cylinder models having pump cover screws without insulators, USA 0A996142 & above and BEL 9483121 & above)● 75/90/115 FourStroke● 150 EFI FourStroke● V.200/225/250 (3.0L)● MerCruiser Alpha One Gen II drives ● ...
Mercury Water Pump Repair Kit 89984Q5
● Mercury Mariner Water Impeller Repair Kit 47-89984Q5 ● Water Impeller Repair Kit Includes new impeller, face plate w/ face plate gaskets, drive key or pin, water tube guide sleeve, O rings and gearlube fill & vent screw seals. ● Fits Mercury/Mariner 65 hp (4 cylinder) through V-6 outboards with short-vane impellers and fits MerCruiser I/R/MR/Alpha drives (s/n 2495186-0D4698...
Turbine Mercury 59362T1
● Number of blades: 8, plastic Hub ● Height: 51.17 mm ● Impeller External diameter: 66.78 mm ● Internal shaft Insert Diameter: 19.04 mm ● Net weight: 94 g ● Replacement: This new aftermarket impeller Replace Mercruiser 47-59362T 1 (47-59362T1 / 47-59362T 1 / 59362T1 / 59362T 1 / 47-593621 / 47-59362 1 / 47-59362-1 / 593621 / 59362 1 / 59362-1 / 47-59362 / 59...
Mercruiser Clamping Screw Starter Motor
● Starter motor holding screw. ● Valid for V6 and V8 starting motors.
Mercruiser Bearing Transom
● Valid for all the transom Alpha One Gen I – Gen II - Bravo
Mercuiser Gasket Set Transmission
• Fits Mercury Mercruiser R/MR/Alpha drives serial numbers 6225577 and above • Properly seals the sterndrive to the bell housing • Consult your engine service manual for further details
Mercuiser Exhaust Bellows Alpha
● Melrruiser exhaust bellows complete with stainless steel clamps. ● For the following models: ALFA ONE (GEN II) BRAVO ONE
Mercuiser Bellows Assembly Universal Joint
● Mercruiser 816431A1 U-Joint Bellows assembly. ● Fits all Alpha I gen II outdrive from 1991 to current units. ● It includes the clip, clamp, and sleeve. ● Bellows adhesive not included.
Quicksilver 4 Stroke Oil 10W30 Synthetic FB 1L
4-stroke 10W30 synthetic oil FB • 1 Liter
Mercury 4 Stroke Oil 10W30 Synthetic FB 4L
● 4-stroke 10W30 synthetic oil FB (new V6 and V8) ● 4 Liters
Mercury Mineral Oil 4 Stroke 4 Liters 25W40
• 4 liters. • 4-stroke mineral oil 25W40.
Mercury Cola Oil RACING and BRAVO DIESEL 1 Liter
● 85W90 Extrem Performance oil for RACING and BRAVO DIESEL transmissions. ● 1 Liter
Mercury Spray Paint SILVER VERADO
● VERADO GRAY spray paint ● 340gr (12 oz)
Mercury Optimax Air Filter
● Air filter for the following Mercury engines: DFI 115 (2000) 130 DFI (1998+) DFI 150 (1998+) 175 DFI (2001+) 200 DFI (1998-02) 225 DFI (1998-02)
Mercury Priming Pear Set
● Design with materials resistant to chemical characteristics to fuels to stay flexible for longer. ● With two hose clamps. ● For use with our 5/16 in (8 mm) fuel line from D.I. (Gray) or the 3/8 "fuel driver from D.I. ● This pear can be used in all applications that are not regulated by the US EPA standard. from 2011.
Mercury Maintenance Kit 300 Hrs F4-F5-F6HP
● Fuel filter. ● Oil drain seal. ● 2 gearbox drain seals. ● Thermostat. ● Thermostat gasket ● Spark plug ● Impeller kit ● Anode ● Models 4/5/6 hp EFI 0R411838 and later.
Mercury Maintenance Kit 300 Hrs F8-F9,9HP
● Fuel filter. ● Oil drain seal. ● 2 gearbox drain seals. ● Thermostat. ● Thermostat gasket ● 2 Spark plugs ● Impeller kit ● Anode ● Only models with standard gearbox 8 / 9.9 hp 0R042475 and later.
Mercury Maintenance Kit 300 Hrs F8-F9,9.CT
● Fuel filter. ● Oil drain seal. ● 2 gearbox drain seals. ● Thermostat. ● Thermostat gasket ● 2 Spark plugs ● Impeller kit ● Anode ● Only 8 / 9.9 hp Command Thrust, 0R042475 and later models.
Mercury Maintenance Kit 300 Hrs F15-F20 H.P.
● Oil filter. ● Fuel filter ● Oil drain seal. ● 3 gearbox drain seals. ● Thermostat. ● Thermostat gasket ● 2 Spark plugs ● Impeller kit ● Anode ● Model 15/20 hp, 0R235949 and later
Mercury Maintenance Kit 300 Hrs F25-F30 H.P.
● Oil filter. ● Fuel filter ● Oil drain seal. ● 2 gearbox drain seals. ● Thermostat. ● Thermostat gasket ● 3 Spark plugs ● Impeller kit ● Anode ● Models 25/30 hp, 0R106999 and later.
Mercury Maintenance Kit 300 Hours F40-F50-F60 BigFoot
● Oil filter. ● High and low pressure fuel filter. ● Oil drain seal. ● 2 gearbox drain seals. ● Thermostat. ● 2 Thermostat joints. ● 4 Spark plugs. ● Water impeller kit. ● Hydraulic compensation anode. ● Lower unit anode. ● 40-60 EFI Cil. FourStroke (BigFoot and CT gearbox only).
Mercury Maintenance Kit 300 Hrs F40-F50-F60 H.P.
● Oil filter. ● High and low pressure fuel filter. ● Oil drain seal. ● 2 gearbox drain seals. ● Thermostat. ● 2 Thermostat gaskets. ● 4 Spark plugs. ● Water impeller kit. ● Hydraulic compensation anode. ● Lower unit anode. ● 40-60 EFI Cil. FourStroke (Standard gearbox only).



























