By creating an account at francobordo.com you can make your purchases quickly in our virtual store, check the status of your orders and check your previous operations.
Ahead! We were waiting for you.
Attwood Battery Clips
● Quick-connect battery clips for 12-volt electrical accessories. 10-amp rated, copper-plated construction with red and black handle grips. For use with wire up to 10-gauge.
Nuova Rade Fixing bracket
● Fixing brackets for battery box or fuel tank
Voltage Sensitive Relay
● This relay charges two batteries at the same time with a single alternator. When the engine is switched on, the Voltage Sensitive Relay stays open until the starting battery reaches 13.7/27 V and then closes the contact and charges the 2 batteries at the same time. When the engine stops and the voltage drops below 12.8/25.2 V, the Voltage Sensitive Relay opens the contact and keeps the two ba...
Electrical shunt boxes 3 inputs
● Electrical shunt boxes ● 3 Inputs: 2 medium y 1 small ● Material: Black Plastic ● 8 clamps ● Dimensions: 76 x 127 x 45 mm
Electrical shunt boxes 6 inputs
● Electrical shunt boxes ● 6 Inputs: 2 large, 2 medium y 2 small ● Material: Black Plastic ● 16 clamps ● Dimensions: 140 x 100 x 53 mm
Automatic Bipolar Battery Switch
● For 2 battery banks. Connected under starter key, if power needs to be cut automatically (in this way the ignition key needs additional tripping) or simply with an ON OFF switch independent. ● Protection IP 65 ● Silver plated copper contacts ● positive or negative Disconnection ● Dimensions: 144 x 95 x 98 mm ● continuous Maximum load: 300A ● Load rating...
Digital Voltage Sensing Relay
● The Digital Voltage Sensing Relay (VSR) allows the charging of a second battery (for example services) from a single source load. When the engine is started and the voltage at the engine battery reaches 60% charge, the VSR into operation also allows charging the second battery. When the battery voltage drops engine (the engine stops for example.) the VSR disconnects and isolates the 2 batteri...
Automatic Charge Relay Series SI-ACR
● Manages automatically load two battery banks and isolates the batteries during power protecting sensitive elements. ● The LED light indicates the ARC states. ● With surface mount options, front or rear panel has a lid that isolates the connections to the terminal and prevent short-circuiting. ● 12 -24 V
Automatic Charge Relay Series M-ACR
● Designed for use in fresh or salt water. waterproof construction. ● Suitable for Wet Cell and AGM batteries. ● Independent outputs. Fully automatic and multi-phase load. Battery maintenance mode. Diagnostic codes. temperature compensated and controlled by microprocessor. LED lights for charge status. Protected against reverse polarity. ● Charging Cables 1.52 mm 0.91 mm DC and AC. ● 12 -24 V ●...
Seachoice Accessory socket with battery clip
● Construction of plastic and brass for use directly with the battery. Accepts most types of cigarette lighter plug ● For 12 volts ● To use up to 50 amps ● Length: 30.5 cm of 18 gauge wire
Seachoice Battery Strap
● Poly-pro webbing. Ideal for securing battery boxes and other equipment. ● Complete with brackets and stainless steel screws. ● Size: 3.8 cm x 1 m
Chrome Plated Alligator Clips
● Red and black alligator clips● Max 10 amps● Crome plated steel
Littelfuse FlexMod Isolator Controller
● Electronic unit designed to preserve the battery charge. ● The unit is autoranging to automatically sense the voltage of the system (12 or 24V). ● It preserves the main battery (starting) power by isolating the auxiliary battery when the system voltage drops below a critical level and it automatically reconnects the battery banks when voltage rises to the correct level. ● Compatible with elec...
Littelfuse FlexMod Connector for Isolator
Littelfuse FlexMod connector for isolator Littelfuse FlexMod isolator controller
Littelfuse Bistable Automatic Relay
● It connects the battery banks (starting + services) when alternator/battery charger are working and it disconnects the banks when the charging system stops. ● It stands power peaks (i.e. powerful inverters). ● In case of emergency battery banks can be connected with a simple switch control. ● It complies with ISO 8846/SAEJ1171. ● Deutsch 6-pole DTM male connector. ● Max capacity - for 10 sec:...
Vetus Dual Relay 12 V, for terminal vanes
● Make/break relay to reverse the direction of rotation of an electric motor, e.g. windlass. Max. output 1.5 kW. - 12V. Referencia Descripción V/W Terminales AFST1512D Double Relé 12/1500 M8 SOL1512D Double Relé 12/1500 M6
Vetus Dual Relay 24 V, for terminal vanes
● Make/break relay to reverse the direction of rotation of an electric motor, e.g. windlass. Max. output 3 kw- 24V/ 6 kw- 24V. Watertight to IP66. Referencia Descripción V/W Terminales SOL324D Double Relé 24/3000 M8 AFST324D Double Relé 24/3000 M6 AFST624D Double Relé 24/6000 M10
Vetus Single Relay 12 V, for terminal vanes
● Simple relay for electric motors, windlasses, etc. Max output 1.5 kW. ● SOL type is waterproof IP66 ● Single Direction Solenoid 12 Volt - 190 Amp (30% Duty Cycle) Referencia Descripción V/W Terminales AFST1512S Single Relé 12/1500 M8 SOL1512S Single Relé 12/1500 M6
Vetus Single Relay 24 V, for terminal vanes
● Simple relay for electric motors, windlasses, etc. Max output 3 kW. ● SOL type is waterproof IP66 ● Single Direction Solenoid 24 Volt - 190 Amp (30% Duty Cycle) Referencia Descripción V/W Terminales SOL324S Single Relé 24/3000 M8 AFST324S Single Relé 24/3000 M6 AFST624S Single Relé 24/6000 M10
Replacement Battery Strap – 39 inches (Mounting Hardware Included)
Just the right battery accessory for long-life battery performance. Battery Box hold down kit that includes stainless steel hardware and 72 inch nylon straps. Includes footman loops and stainless steel screws. 39″ Strap (102cm)
6,99€
Relay box 12V / 24V Ultraflex
● Relay boxes enable cycle inversion and synchronization Code Model Volt 40738Y RB12 12 V 40742C RB24 24 V
Battery switch with stainless steel body
Battery disconnect switch in black polycarbonate with flange mounting. Extra version with AISI 316 stainless steel body. Neck fastening with double threaded nut. Extremely robust. Complete with waterproof PVC cover and splashproof key in nickel-plated brass. CE certified according to directive 94/25/CE (UNI EN ISO 8846). Mandatory device to be installed on the positive cable, ISO 10133 standard...
Replacement Strap for Battery Box
Replacement Strap for Battery Box 14.546.02
Replacement Strap for Battery Box
Replacement Strap for Battery Box 14.546.01
