Inverter/charger of Victron Energy that combines the inverter function with that of a battery charger, with two AC outputs and compatibility with Lithium-Ion batteries. The main output has the "no-break" (uninterrupted) function: the MultiPlus takes care of supplying the connected loads in the event of a power cut or disconnection from the mains/generator. This happens so quickly (less than 20 milliseconds) that computers and other electronic equipment continue to operate without interruption.
The second output is only active when one of the MultiPlus inputs has AC power. Devices that should not discharge the battery, such as a water heater, for example, can be connected to this output (second output available on models with a rated capacity of 3kVA or more).
*Photo for guidance
System functions
Virtually unlimited power thanks to parallel operation
Up to 6 Multis can operate in parallel to achieve a higher output power. Six 24/500/120 units, for example, will give an output power of 25kW/30 kVA and a charging capacity of 720 amps.
Three-phase operation capability
In addition to parallel connection, three units of the same model can be configured for a three-phase output. But that is not all: up to 6 sets of three units can be connected in parallel, providing an output power of 75kW / 90 kVA and more than 2000 amps of charging capacity.
PowerControl: limited power from the generator, shore power inlet or mains
The MultiPlus is a very powerful battery charger. It will therefore draw a lot of current from the generator or the pontoon mains supply (almost 10A for each Multi of 5 kVA at 230 VAC). A maximum current from the generator or pontoon can be set on the Multi Control Panel. The MultiPlus will take care of other AC loads and use the surplus current for charging, thus avoiding overloading the generator or the shore power inlet.
PowerAssist: boosting the electrical capacity of the shore power inlet or generator
This function takes the PowerControl principle to another dimension. It allows the MultiPlus to supplement the capacity of the alternative source. When a power peak is required for a short period of time, as often happens, the MultiPlus will immediately compensate for the possible lack of power from the mains or generator current with battery power. When the load is reduced, the surplus power is used to recharge the battery.
Solar energy: AC power available even during a power cut
The MultiPlus can be used in PV systems, whether grid-connected or not, and in other alternative electrical systems. Software for detecting loss of supply is available.
System configuration
- In the case of a stand-alone application, if the configuration has to be changed, this can be done in a matter of minutes using a DIP switch configuration procedure.
- Parallel or three-phase applications can be configured with the VE.Bus Quick Configure and VE.Bus System Configurator software.
- Off-grid, grid-interactive and self-consumption applications involving grid-connected inverters and/or MPPT solar chargers can be configured with assistants (software specific to particular applications).
On-site monitoring and control
Several options are available: Battery Monitor, Multi Control Panel, VE.Net Blue Power panel, Color Control panel, smartphone or tablet (Bluetooth smart), laptop or computer (USB or RS232).
Remote monitoring and control
Victron Ethernet Remote, Victron Global Remote and the Color Control Panel. Data can be stored and displayed free of charge on the VRM (Victron Remote Management) website.
Remote configuration
Data can be accessed and system settings changed with a Color Control panel if it is connected to Ethernet.
Technical specifications