● Garmin Boat Switch lets you operate up to 20 tracks directly from your GPSMAP or ECHOMAP chartplotter.
● Offers four different types of switches including on/off for bilge pumps and navigaion lights, pressure and hold dimmers for cabin lights, momentary outputs for horn, and a timer to cycle your water pump.
● Provides integrated tank monitoring and calibration for up to four tanks, including fuel, freshwater, greywater, blackwater and nursery.
Main Features
● All in one: Replaces existing two-element systems (fuse box and switches) to facilite control and operation of on-board functions.
● Digital control: Control and protect up to 20 circuits from the plotter instead of using a physical button or switch.
● On/Off Switches: Switching outputs control the bilge pump and non-dimmable lights, such as navigation and courtesy lights.
● Dimmable outputs: Push dimmers allow you to adjust the onboard brightness to your liking.
● Momentary departures: Control speakers and much more. You just have to press and hold and release depending on the desired duration of the sound.
● Nursery timer: A built-in timer causes the pump to recycle water to keep fish alive and pumps running longer.
● Monitor deposits: Detects and calibrates the transmitter for up to four tanks, such as fuel, freshwater, gray/black water and livewell.
● Additional Inputs: View internal and starting battery voltages, monitor bilge pump operation and connect optional hardware switches.
● Upgrade your boat: Install the system on existing boats without special tools or setup using the 18" conductor cables and color-coded channel cables.
Technical Features
General
● Measures: 230 x 106 x 38 mm
● Weight: 400 gr
● Room temperature: From -20ºC to 55ºC
● Water Classification: IP65
● Communication: CAN-bus NMEA 2000 network, LEN-0
● Departures: 13 canales 10A y 7 canales 5A
Input
● Ground switch input: 15
● Bilge pump monitor: 2
Analog input
● Volts: 3 @ 0-16V +/-1%
● Resistence: 2 @ 0-1500 ohm +/-5%
Power supply
● Maximum current: 50A
● Power consumption OFF: 60 mA
● Supply voltage (12V): 9-16 VCC
ConNector
● NMEA 2000: Micro 5-pin M12 (male)
● Channels: Molex MX150L 16 (circuits)
● Power terminal: M6 bolt.
In the box
● Garmin boat switch
● Wiring harness for Garmin Boat Switch X1
● Wiring harness for Garmin Boat Switch X2
● Installation instructions
