Inverter/charger compatible with Lithium-Ion batteries. *Photo for guidance
The second output is only active when one of the MultiPlus inputs has AC power. Appliances that should not discharge the battery, such as a water heater, can be connected to this output (second output available on models with a rated capacity of 3kVA or more).
Virtually unlimited power thanks to parallel operation
Up to 6 Multis can operate in parallel to achieve a higher output power. Six units 24/500/120, for example, will give an output power of 25kW/30 kVA and a charging capacity of 720 amperes.
Three-phase operation capability
In addition to parallel connection, three units of the same model can be configured for a three-phase output. But that is not all: up to 6 sets of three units can be connected in parallel to provide an output power of 75kW / 90 kVA and more than 2000 amperes of charging capacity.
PowerControl: limited power from the generator, shore power inlet or mains
The MultiPlus is a very powerful battery charger. It will therefore draw a lot of current from the generator or the marina mains (almost 10A for each Multi of 5 kVA at 230 VAC). A maximum current from the generator or the marina can be set on the Multi Control Panel. The MultiPlus will take over other AC loads and use the surplus current for charging, thus avoiding overloading the generator or the shore power inlet.
PowerAssist: boosting the electrical capacity of the shore power inlet or the generator
This function takes the PowerControl principle to another dimension. It allows the MultiPlus to supplement the capacity of the alternative source. When a power peak is required for a short period of time, as often happens, the MultiPlus will immediately compensate for the possible lack of power from the mains or generator current with battery power. When the load is reduced, the surplus power is used to recharge the battery.
Solar energy: AC power available even during a power cut
The MultiPlus can be used in PV systems, connected to the mains or not, and in other alternative electrical systems. Software for detecting a lack of supply is available.
System configuration
- In the case of a stand-alone application, if the configuration has to be changed, this can be done in a matter of minutes using a DIP switch configuration procedure.
- Parallel or three-phase applications can be configured with the VE.Bus Quick Configure and VE.Bus System Configurator software.
- Off-grid, grid-interactive and self-consumption applications involving grid-connected inverters and/or MPPT solar chargers can be configured with assistants (software specific to particular applications).
Monitoring and control
On site
Several options are available: Battery Monitor, Multi Control Panel, VE.Net Blue Power panel, Color Control panel, smartphone or tablet (Bluetooth smart), laptop or computer (USB or RS232).
Remote
Victron Ethernet Remote, Victron Global Remote and the Color Control Panel. Data can be stored and displayed free of charge on the VRM (Victron Remote Management) website.
Remote configuration
Data can be accessed and system settings changed with a Color Control panel if it is connected to Ethernet.
Technical specifications