By creating an account at francobordo.com you can make your purchases quickly in our virtual store, check the status of your orders and check your previous operations.
Ahead! We were waiting for you.
Register and take advantage of the discounts and advantages of being a Professional of Nautical
Join the more than 500 Nautical Professionals now
Fuel level.
• Like all products in the Wema range, these analogue instruments are built to last. Designed to be accurate, reliable and dependable over years of use.
• Running out of fuel unexpectedly is, at best, an inconvenience. A fuel gauge you can trust and depend on really matters — and consistent, accurate readings over years of use is what these are designed to deliver.
• The IP67 rating means that the gauge is waterproof to up to 1m underwater for 30 minutes and although we hope it never comes to that, it does mean that the gauge is sealed completely from all weather and dust ingress.
• Fits any standard 52mm panel cutout. Retrofits straight into most existing dashboards without modification, or drops into any new installation.
• Works with any resistance sender of the correct range — Wema S3 or S5, or any sender from another manufacturer with a matching resistance.
• Available in European (0-190Ω) resistance.
• Sender and gauge must have the same resistance range — or the gauge will read backwards, or not at all.
• Runs on 12V. For 24V systems a dropping resistor is supplied — or a voltage regulator for a cleaner, more stable long-term solution.
• Red or amber backlight. Available in black or white face with black, white or brushed stainless bezel — the same styling runs across the full Wema gauge range, so everything matches.
• We stand behind our products with a 3-year guarantee.
• You will need a minimum clearance of 55mm (2 3/16") behind the panel to fit the gauge.
• Remove fastening ring and insert gauge through panel from the front, fit and tighten fastening ring from the rear.
• Connect wires according to wiring diagram.
• Select either Orange or Yellow wires for backlighting. Wire colour corresponds with backlight colour.
• Note the use of dropping resistors for 24V circuit.
• Insert wire harness into port at the back of the gauge.
| Reference | Color | Diameter | Hole diameter |
| 110320 | Black/Black | 62 mm | 52 mm |
| 110324 | White/White | 62 mm | 52 mm |
| 110620 | Black/Stainless Steel | 56 mm | 52 mm |
| 110624 | White/Stainless Steel | 56 mm | 52 mm |
